Power UNITS FOR LIFT TABLE 1
General Description
This energy unit is created solely for the small lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be extensively used inside the business of logistic devices for instance minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed through the solenoid valve with all the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is built solely for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed through the adjustable needle valve. When the lift rises to a higher positoin, however the electrical power provide is reduce, the decreasing movement is controlled through the guide override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This electrical power unit is built solely for the large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and also the pace managed by a pressure compensated flow control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is created solely for your huge lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the speed controlled through the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy provide is minimize, the lowering movement is controlled by the guide override perform.
Exclusive Notes
1. This power unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic components concerned in advance of installation of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is suggested.
four. Oil changing is needed after the first 100 operation hours,afterwards once each and every 3000 hours.
five. The power unit shown is created to be mounted vertically.